DIN 96x48mm 4 DIGIT DISPLAY ONLY MICROPROCESSOR METER AC & DC VOLTAGE & CURRENT, DC ANALOGUE SIGNALS, THERMOCOUPLE, PT100 & PT1000 INPUTS

Din 96x48mm 4 digit panel meters, available with a wide choice of AC & DC voltage and current inputs, including DC analogue signal inputs, thermocouple inputs and PT100, PT1000 inputs. The meters are can be programmed by four tactile switches that can be specified to be accessed directly on the front panel or specified as discrete, where the buttons are hidden behind the front screen. These meters are display only meters and have no outputs, for meters with outputs please see meter range CS1 & CS2.

All meters, in particular analogue input meters can be scaled to other engineering values, including negative to positive scaling and offset zero.

Programming & set up buttons can be specified with “Visible Buttons” on the front panel or “Discrete Buttons” behind the front screen. If not specified, meter will be supplied with “Discrete Buttons”.

The following functions can be set up at the time of ordering, or programmed if required at a later date:

AvG to increase or decrease the response time, factory default 100mSec

dF iLT to increase filtering on noisy supplies possibly to be utilised in conjunction with AvG.

LoCUt to ignore induced readings at zero from leaky circuits or noise pick up, but not at the detriment of a real reading. For example if LoCUt value of 5 set, any reading of 5 or below is ignored, but when reading is genuinely say 100 the meter reads 100 and not 95.

AoLS low scale point when scaling say to other engineering values, can be set from -1999 to +9999 the meter has the facility to also fine adjust.

AoHS high scale point when scaling say to other engineering values, can be set from -1999 to +9999 the meter has the facility to also fine adjust

Further details and assistance on the above set up features are available from our sales office.

Measuring accuracy (PR): < +0.1% FS + 1 digit

Measuring accuracy (TC): < +0.2% FS + 1 digit

Measuring accuracy (TR): < +0.2% FS + 1 digit

Temperature effect: < 100 PPM/°C

Sampling rate: 15 cycles / sec

Response time: < 100mSec (standard) Can be altered in set up

Display: 4 x 20mm high red LED’s

Display range: -1999 to +9999

Decimal point: At any point or not at all

Over range indication: “ouFL” when input is >110% of input range

Under range indication: “-ouFL” when input is < LoSC value

Aux Supply
ADH: 85-264VAC & 100-300VDC
ADL: 20-56VAC/DC

Power consumption:
AC: < 8VA
DC: < 4W

Back up memory: EPROM

Operating temperature: 0-60°C

Operating humidity: 20-95% RH

Dielectric strength: 2KV for 1 min, between input & aux.

Insulation resistance: ≥100MOhms @ 500VDC between input & aux

EMC: EN55011:2002 & EN 61326:2003

Low voltage directive: EN61010-1:2010

Dimensions mm: 96(W) x 48(H) x 80(D)

Panel cut out mm: 92(W) x 45(H Case material: ABS (UL 94V-0)

Terminals: Screw max 2mm²

The meter will be scaled exactly to your requirements

*For voltage inputs in excess of 600V, please use meter type CS1

**On TC, TR & TRK input meters, scaling can also be on request in ‘F’

***An optional (extra cost) 24VDC built in excitation voltage output can be specified, max 30mA

Please also specify if front programming / set up buttons are to be “Visible” or “Discrete”